User's Manual

10
16
14. Lay the Cable (49) over a Pulley (45). Attach the
Pulley, a Cable Trap (53), two Bushings (46), and
two M10 W
ashers (6) to the Lat Tower (41) with
an M10 x 85mm Bolt (58) and an M10 Nylon
Locknut (1
1). Make sure that the Cable T
rap is
oriented to hold the Cable in place, as shown.
15. Press Oval Bushings (44) into the top and bottom
of the Weight Carriage (42). Press a 25mm
Round Inner Cap (36) into each end of the weight
tube on the Weight Carriage.
Insert an M10 x 20mm Bolt (50) into the bracket
on the Weight Carriage (42). Slide the Weight
Carriage onto the bottom of the Lat Tower (41).
Make sure that the Weight Carriage is oriented
as shown.
Slide the loop on the Cable (49) onto the M10 x
20mm Bolt (50) and secure it with an M10 Nylon
Locknut (11).
16. Attach the Plastic Stop (37) to the Curl Bar Tube
(34) with the ST4 x 15mm Screw (57).
Lubricate two M10 x 70mm Bolts (28) with grease.
Attach the Curl Bar
Tube (34) to the Leg Lever (7)
with an M10 x 70mm Bolt and an M10 Nylon
Locknut (1
1).
Attach the Curl Bar (51) to the Curl Bar Tube (34)
with the other M10 x 70mm Bolt (28) and an M10
Nylon Locknut (1
1).
Do not overtighten the M10 Nylon Locknuts
(1
1); the Curl Bar T
ube (34) must be able to
pivot easily.
51
1
1
7
1
1
28
57
37
34
28
Lubricate
Lubricate
58
46
6
6
46
49
53
45
11
41
14
41
44
36
36
49
11
Bracket
50
44
42
Weight
Tube
15