User's Manual

7. Turn the indicated Adjustment Knob (28) counterclock-

wise two or three turns to loosen it. Next, pull the Knob,

insert the Seat Post (5) into the Frame (1), and then

release the Knob. Move the Seat Post up and down

slightly until the pin on the Knob snaps into one of

the holes in the Seat Post. Then, turn the Knob clock-

wise until it is tight.

6. Hold the Console (16) near the Upright (13). Connect

the console wire to the Upper Wire Harness (36).

Insert the excess wire into the Upright.

Attach the Console (16) to the Upright (13) with four

M4 x 16mm Screws (66). Be careful to avoid pinch-

ing the wires.

5. Slide the two slots in the Handlebar Clamp (49) onto the

two indicated tabs on the Upright (13). Lift the bottom of

he Handlebar Clamp away from the Upright, and insert

the Handlebar (15) between the Handlebar Clamp and

the Upright. Centre the Handlebar and rotate it to the

desired position.

Slide an M8 Washer (67) onto the Adjustment Handle

(53). Insert the Adjustment Handle into the Handlebar

Clamp (49) and tighten the Adjustment Handle into the

Upright (13). Note: The Adjustment Handle works like a

spanner. Turn the Handle clockwise, pull it away from

the Upright, turn it counterclockwise, push it toward the

upright, and then turn it clockwise again.

Tabs

Console

Wire

8. Attach the Seat (12) to the Seat Bracket (6) with four

M8 Nylon Locknuts (10) and four M8 Split Washers

(64). Note: The Nylon Locknuts and the Split Washers

may be pre-attached to the underside of the Seat.

Turn the Adjustment Knob (28 counterclockwise two or

three turns to loosen it. Next, pull the Knob, slide the

Seat Bracket (6) into the top of the Seat Post (5), and

then release the Knob. Move the Seat Bracket for-

ward and backward slightly until the pin on the

Knob snaps into one of the holes in the Seat

Bracket. Then, turn the Knob clockwise until it is tight.

Note: If desired, you can attach your own seat to the

exercise cycle using the Adapter Bracket (not shown) in

place of the Seat (12) and the Seat Bracket.