User's Manual

10
8. Orient the Handlebar Cover (67) as shown and
hold it near the Handlebar (7).
Connect the receiver wire (B) to the Extension
Wire (102). Carefully insert the excess wire into
the Handlebar (7).
Tip: Avoid pinching the wires. Insert a #8 x
5/8" Screw (94) upward into the front hole in the
Handlebar (7). Set the Handlebar Cover (67) on
the Handlebar, and tighten the Screw into the
Handlebar Cover.
Next, insert a #8 x 5/8" Screw (94) into the rear
hole in the Handlebar (7), and tighten the Screw
into the Handlebar Cover (67).
9. See the inset drawing. Remove the two indi-
cated screws (C) from the back of the Console
(9), and remove the back of the Console. Do
not discard the screws; they will be used in a
later step.
Attach the Console (9) to the Handlebar (7) with
four #8 x 5/8" Screws (94).
8
9
Avoid pinching
the wires
94
67
B
102
7
94
94
C
9
9
7