User's Manual

HOW TO MAINTAIN THE EXERCISE BIKE

Inspect and tighten all parts of the exercise bike regu-

larly. Replace any worn parts immediately.

To clean the exercise bike, use a damp cloth and a

small amount of mild detergent. IMPORTANT: To

avoid damage to the console, keep liquids away

from the console and keep the console out of

direct sunlight.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed

switch, first press

the power switch to

the off position and

unplug the power

cord. Then, use a flat

screwdriver to remove

the Upper Shield (10)

from the exercise bike.

Locate the Reed Switch (35). Loosen, but do not

remove, the two #8 x 19mm Tek Screws (97).

Next, rotate the Crank Pulley (53) until a Magnet (55)

is aligned with the Reed Switch (35). Slide the Reed

Switch slightly toward or away from the Magnet. Then,

retighten the #8 x 19mm Tek Screws (97).

Plug in the power cord and press the power switch to

the reset position. Rotate the Crank Pulley (53) for a

moment. Repeat these actions until the console dis-

plays correct feedback.

When the reed switch is correctly adjusted, reattach

the upper shield.

MAINTENANCE AND TROUBLESHOOTING