Warranty

ManualsBrandsProForm ManualsCardio EquipmentStudio Bike Pro

HOW TO MAINTAIN THE TRAINING BIKE

Regular maintenance is important for optimal

performance and to reduce wear. Inspect and properly

tighten all parts each time the training bike is used.

Replace any worn parts immediately.

To clean the training bike, use a damp cloth and a

small amount of mild detergent. IMPORTANT: To

avoid damage to the console, keep liquids away

from the console and keep the console out of

direct sunlight.

CONSOLE TROUBLESHOOTING

If the console does not turn on, make sure that the

power cord is fully plugged in and that the power

switch is in the reset position. If there are exterior wires

on the console, make sure that the connectors on the

wires are oriented correctly and are connected firmly.

If you are having problems connecting the console

to a wireless network or if you are having problems

with your iFit account or iFit workouts, go to

support.iFit.com.

If the console does not boot

up properly, or if the con-

sole freezes and does not

respond, reset the console

to the factory default set-

tings. IMPORTANT: Doing

this will erase all custom settings you have made

to the console. Resetting the console requires two

people. First, unplug the power adapter. Next, locate

the small reset opening (A) near the USB port on the

console. Using a bent paper clip, press and hold the

reset button inside the opening, and have a second

person plug in the power adapter. Continue holding the

reset button until the console turns on. When the reset

operation is complete, the console will turn off and then

turn back on. If it does not, press the power switch off

and then on again. Once the console turns on, check

for rmware updates (see step 5 on page 20). Note:

It may take a few minutes for the console to be ready

for use.

TABLET HOLDER TROUBLESHOOTING

If the tablet holder does

not stay in place, rotate

the tablet holder backward

and tighten the screw (B)

until the tablet holder stays

in place when it is rotated

to the desired position.

INCLINE SYSTEM TROUBLESHOOTING

If the frame does not move to the correct incline level,

see HOW TO CHANGE CONSOLE SETTINGS on

page 26 and calibrate the incline system.

To prevent interference

with the resistance

magnet, make sure that

the adjustment handle(C)

on the rear of the frame is

pointing upward.

MAINTENANCE AND TROUBLESHOOTING