Instructions / Assembly

9
2
3
Indicators
47
3
3. If there are shipping screws in the Rear
Stabilizer (23), remove and discard them.
Attach the Rear Stabilizer (23) to the Base (1)
with two M10 x 58mm Screws (74).
74
23
1
4. Using a plastic bag to keep your fingers clean,
apply some of the included grease to the sides
of the channel on the top of the Saddle Post (3).
Next, orient the Saddle Post (3) so that the
height indicators are on the side shown.
Loosen the indicated Adjustment Handle (47),
and insert the Saddle Post (3) into the Frame (2).
Move the Saddle Post upward or downward
to the desired position, and then tighten the
Adjustment Handle. When you are finished
tightening the Adjustment Handle, make sure
that the end of the Adjustment Handle is
pointing upward.
Note: The Adjustment Handle (47) functions
like a ratchet. Turn the Adjustment Handle in
the desired direction, pull it outward, turn it in
the opposite direction, push it inward, and then
turn it in the desired direction again. Repeat this
process as many times as necessary.
4
Grease