Tempest User's Manual

3. Make sure that a qualified electrician has wired

the spa to a 240 volt power source.

Remove the two warning decals (see page 5) from

he spa shell. Using a damp cloth, wipe the spa shell

clean.

Before filling the spa, make sure that it is

in the desired position and that there is room to

easily service it. Once the spa is filled, it will

have to be drained before it can be moved.

Insert a garden hose into the filter housing, and fill

the spa.

Do not use soft water. The spa may be

filled with cold water; however, if warm or hot water

is used, the spa will be ready for use sooner. Fill the

spa until the water is at the level of the molded fill

line.

Do not overfill the spa.

See the inset drawing. Set the Filter (5) and the

Basket (22) into the filter housing. Next, place the

Filter Cover (3) into the filter housing until it is fully

seated.

4. Pull down one of the straps on the Spa Cover (11)

and hold the Buckle (26) against one of the panels on

the spa. (Note: To position the Buckle correctly, have

a second person hold the strap on the opposite side

of the Spa Cover snug.) The Spa Cover must be

snug. Do not place the Buckle over the grooves

between the premium cedar panels.

See the inset drawing. Remove the latch from the

Buckle. Attach the Buckle to the panel with two #4 x

3/4” Screws (27). Attach the other three Buckles (26)

to the panels in the same way.

Remove the Spa Cover (11) from the spa.

Fill to here

Garden

Hose

Filter

Housing

Strap

Latch