Tempest User's Manual

Your spa features an LED light with twelve different

programmed lighting effects:

. Lights cycle between Red, Green, and Blue

2. Dark Blue

. Orange

4. Purple

5. Green

6. Red

7. Hot Pink

8. Cyan

9. White

10.Color Spectrum (each color is displayed for

approximately one minute)

11. Blue/Green Mix

12.Party ModeTM (colors cycle rapidly through the

color spectrum)

The

Light button controlls the LED light. To turn the

light on, press the light button. To turn the light off,

press the light button again. To select the next lighting

effect, turn the light off and then within five seconds

turn it on again. If the light is left off for more than five

seconds, the same lighting effect will be displayed the

next time the light is turned on.

The

Temperature buttons control the temperature set-

ting of the water. The temperature setting can be from

0°F to 104°F. The startup temperature is set at

100°F. The water heats at about 6°F per hour with the

over on. Use a medical or other accurate thermome-

ter to check the temperature of the water.

To change the water temperature, press the tempera-

ture up or down button until the desired temperature is

reached. After three seconds, the console will auto-

matically display the last measured water temperature.

If the temperature sensors detect a drop below 40°F,

then pump 1 (and the heater if necessary

)

will automat-

ically activate to provide freeze protection. The equip-

ment will stay on until the sensors detect that the spa

temperature has risen to within 15°F of the set temper-

ature. Pump 2 and the blower will purge for 30 sec-

onds to 2 minutes at the end of the freeze condition.

The

Blower button turns the ten air injectors, labeled 5

in the small drawing on page 14, on and off.