User's Manual

10
13. Orient a Weight Guide (30) with the indicated
hole closer to the bottom. Attach the Weight
G
uide to the Center Base (5) with an M10 x
65mm Bolt (110), two M10 Washers (109), a 1/2"
S
pacer (68), and an M10 Nylon Locknut (111).
Slide a Weight Bumper (66) onto the Weight
Guide.
Attach the other three Weight Guides (30) to
the Center Base (5) in the same manner.
Tighten the M10 x 70mm Bolts (57) used in
step 3.
14. Slide eleven Weights (34), with the pin grooves
on the bottom, onto a set of Weight Guides (30).
Orient a Weight Tube (75) as shown. Insert the
Weight Tube into the stack of Weights (34).
Slide another Weight (34) onto the set of Weight
Guides (30).
Repeat this step with the other stack of
Weights (34).
3
0
3
0
13
66
68
110
5
111
109
Hole
75
34
30
34
14
34
Pin
Groove