User's Manual

17
38. Wrap the Low Cable (70) over a Pulley (43).
Attach the Pulley, a Cable Trap (48), and two Half
F
inger Guards (46) at the bottom hole of the pair
of Pulley Plates (49) with an M10 x 50mm Bolt
(
106) and an M10 Nylon Locknut (111). M
akes
sure that the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
39. Attach the Low Cable (70) inside the Right Base
(1) with an M10 x 65mm Bolt (110), two M10
Washers (109), and an M10 Nylon Locknut (111).
40. Locate the High Cable (88). Route the Cable up
through the Left Top Frame (4) and over a Pulley
(43). Attach the Pulley inside the Top Frame with
an M10 x 65mm Bolt (110), two M10 Washers
(109), two 1/2" Spacers (68), and an M10 Nylon
Locknut (111).
41. Route the High Cable (88) over a Pulley (43) and
down through the Left Top Frame (4). Attach the
Pulley inside the Top Frame with an M10 x 65mm
Bolt (110), two M10 Washers (109), two 1/2"
Spacers (68), and an M10 Nylon Locknut (1
1
1).
43
46
4
6
49
106
111
70
48
38
39
1
111
109
70
110
109
41
42
110
40
110
68
43
109
109
1
11
68
88
4
88
46
46
48
43
50
106
111
109
42. Wrap the High Cable (88) under a Pulley (43).
Attach the Pulley
, a Cable
T
rap (48), an M10
Washer (109), and two Half Finger Guards (46) at
the second hole from the top of the Small Pulley
Plate (50) with an M10 x 50mm Bolt (106) and an
M10 Nylon Locknut (1
1
1).
Makes sure that the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley
.
68
68
43
4
88
109
109
111