User's Manual

USING THE LEG LEVER LOCK

When using the low pulley station, engage the Leg

Lever Lock (47) onto the Leg Lever (15) tube.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight

system, can stretch slightly when it is first used. If

there is slack in the cables before resistance is felt,

the cables should be tightened. To tighten the cables,

first insert the weight pin into the middle of the weight

stack. Slack can be removed from these cables in

several ways:

See drawing A. Remove the M10 Nylon Locknut (111)

and the M10 x 50mm Bolt (106) from the indicated

Pulley (43), Cable Trap (48), Half Finger Guards (46),

and Pulley Plates (49). Reattach the Pulley, Cable

Trap, and Finger Guards using a hole closer to the

center of the Pulley Plates.

Make sure that the

Cable Trap is oriented to hold the cable in the

groove of the Pulley, that the Finger Guards are

oriented as shown, and that the Cable and Pulley

move smoothly. Adjust the top Pulley (43) in the

same manner, if necessary.

See drawing B. Adjust the Pulley (43) attached to the

Small Pulley Plate (50) as described above. To

remove more slack, tighten the M6 Nylon Locknut

(103) further onto the end of the Press Cable (72).

106

111

103