User's Manual

18. Lower the Frame (64) (see HOW TO LOWER

THE TREADMILL FOR USE on page 29).

If one of the Rear Leveling Feet (69) doesn’t sit

flat on the floor, turn the Rear Leveling Foot until

it does, and then tighten the 1/2" Rear Leveling

Foot Nut (41) against the Frame (64). Make sure

that both 1/2" Rear Leveling Foot Nuts are

tightened against the Frame.

17. Attach the upper end of the Storage Latch (65)

to the Frame (64) with a 3/8" x 1 3/4" Bolt (7)

and a 3/8" Nut (13). Note: It may be necessary

to move the Frame back and forth to align the

Storage Latch with the Base (not shown).

19. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic

on the treadmill decals, remove the plastic. To protect the ﬂ oor or carpet, place a mat under the treadmill.

Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is

used to adjust the walking belt (see pages 31 and 32).