User's Manual

8
1
INSERT
KEY
OFFON
2
RESET /
SET SPEED
RESET
Aerobic
Fat Burn
Performance
W
arm-Up &
Cool-Down
SL
OW
FAST
SPEED
PULSE
TIME
CALORIES
ON/CLEAR
THUMB PULSE
DIST
ANCE
Minimum
Maximum
ET-385
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the power
cord is properly plugged in. (See HOW TO PLUG IN
THE POWER CORD on page 7.)
The console requires two "AA" batteries (not in-
cluded); alkaline batteries are recommended. Open the
battery cover as shown in the drawing at the upper right.
Press two batteries into the battery compartment, with
the negative (-) ends of the batteries touching the
springs. Close the battery cover.
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing at the top of
this page), and slide the clip onto the waistband of your
clothing.
Follow the steps below and on page 9 to operate the
console.
Insert the key fully into the power switch.
Inserting the key will not
turn on the displays. The
displays will turn on
when the ON/CLEAR
button is pressed or the
walking belt is started.
Note: If you just installed
batteries, the displays will already be on.
CAUTION: Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) while operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
• Adjust the speed in small increments until
you are familiar with the treadmill.
• The training zones marked beside the speed
control are general guidelines only. See
pages 14 and 15 for more information.
•
To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console, and use only a sealed water
bottle.
1
INSERT
KEY
OFFON
DIAGRAM OF THE CONSOLE
Clip
Key Speed Control
Note: If there is a thin
sheet of clear plastic
on the face of the
console, remove it.
Batteries
Battery Cover
1
Pulse Sensor