User's Manual

3. Orient a Handrail Spacer (106) so that the arrow be-

tween the two holes points upward. Thread the Wire

Harness (42) through the upper hole in the Handrail

Spacer as shown. Identify the Right Handrail (72), which

has a large hole in the side near the upper end. Insert

the Wire Harness into the Right Handrail and out of the

large hole. If necessary, use needlenose pliers to pull the

Wire Harness out of the hole.

Hold the Handrail Spacer (106) and the Right Handrail

(72) against the right Upright (73). Attach the Right

Handrail and the Handrail Spacer with two 3” Handrail

Bolts (61) and two 5/16” Star Washers (63) as shown.

Do not tighten the Handrail Bolts yet.

Attach the Left Handrail (not shown) to the Left Upright

(73) as described above. Note: There is not a wire har-

ness in the Left Upright.

4. Set the Crossbar (40) on the brackets on the Handrails

(71, 72). Attach the Crossbar with two Crossbar Screws

(39).

Do not tighten the Crossbar Screws yet.

Attach the end of the ground wire to the small hole in the

side of the Right Handrail (72) with a 1/2” Silver Screw

(49).

Ground

Wire

Bracket

Ties

5. Place the Console Base (47) on the Right Handrail (72)

and the Left Handrail (not shown). Attach the Console

Base with four 3/4” Screws (2) (only two Screws are

shown).

Insert the Wire Harness (42) through the two indicated

plastic ties on the Console Base (47). Next, insert the

Wire Harness up through the opening beside the Console

Cover (44). Make sure that the Console Cover is securely

attached to the Console Base.

Refer to the inset drawing. Look at the top of the Console

Base (47). Insert the Wire Harness (42) through the

plastic tie on top of the Console Base.

Tie

106