User's Manual

13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic

on the treadmill decals, remove the plastic. To protect the oor or carpet, place a mat under the treadmill.

Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is

used to adjust the walking belt (see page 22).

12. Orient the Latch Assembly (68) as shown. Attach

the Latch Assembly to the Left Upright (66) with

two #10 x 3/4" Screws (8); start both Screws,

and then tighten them.

11. Insert the wires into the Right Handrail (64)

through the indicated hole as you set the con-

sole assembly on the Uprights (66, 76). Make

sure that no wires are pinched.

Attach the console assembly with ten #8 x 3/4"

Screws (4). Start all ten Screws, and then

tighten them. Do not overtighten the Screws.

See step 5. Firmly tighten the six 3/8" x 3 1/4"

Screws (2).

Wires

Hole

Console Assembly