User's Manual

If you purchase the optional chest pulse sensor (see page 16), follow the steps below to install the receiver

included with the chest pulse sensor.

1. Make sure that the key is removed from the console

and that the power cord is unplugged.

Remove the indicated Screw (3) and the Access Door

(76) from the back of the Console Base (85).

2. Connect the wire on the receiver (A) to the indicated wire

extending from the Console Base (85). Hold the re-

ceiver so the small cylinder is oriented as shown and

is facing the Console Base. Attach the receiver to the

plastic posts on the Access Door (76) with the two in

cluded small screws.

Make sure that no wires are pinched. Reattach the

Access Door (76) with the Screw (3). Discard the other

wires included with the receiver.

Small

Cylinder

Wire

Small

Screws

6. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear

plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-

mill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place; the large allen

wrench is used to adjust the walking belt (see page 20).

. Attach the Weight Rack (93) (only one end is shown) to

the Uprights (84) with two Rack Bolts (91) and two Rack

Washers (92). Start both Rack Bolts and then tighten

them.

Place the Weights (not shown) on the Weight Rack (93).