- Proform USERS MANUAL Treadmill PFTL58590

1. With the help of a second person, carefully raise the

treadmill to the upright position.

While the other person tips the treadmill to one side and

holds it, insert an Extension Leg (59) into one side of

the treadmill. Make sure that the Extension Leg is

turned so the bracket is on the top as shown. Using the

Allen Wrench (102), Attach the Extension Leg with an

Extension Leg Screw (57). Attach the other Extension

Leg in the same manner.

Note: One replacement Base Pad (55) may be included.

Use the extra Pad if one becomes worn or needs to be

replaced.

2. Refer to HOW TO LOWER THE TREADMILL FOR

USE on page 11. Follow the instructions in step 2 to

lower the treadmill.

Cut the plastic ties holding the cage nuts in the upper

end of each Handrail (60, 62).

Position the Left Handrail (60) on the left Upright (32) as

shown. The bracket on the Extension Leg (59) should

be inside of the lower end of the Left Handrail (see the

inset drawing). Thread two Handrail Bolts (30) with

Handrail Washers (40) into the left Upright and the Left

Handrail. Do not tighten the Handrail Bolts yet.

While another person holds the Console Base (46),

insert all excess Wire Harness (35) through the Right

Handrail (62) and into the right Upright. Next, attach the

Right Handrail in the same way that you attached the

Left Handrail. Be careful to avoid damaging the Wire

Harness (35).

102

Bracket

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not

ispose of the packing materials until assembly is completed.

ssembly requires the included allen wrench

and your own phillips screwdriver , adjustable wrench , and scissors .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a

small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal

condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off

the lubricant with a soft cloth and a mild, non-abrasive cleaner.