User's Manual

7
3. Identify the Right Upright (79) and the Right
Upright Spacer (83), which are marked with
stickers. Insert the Upright Wire (86) through the
Right Upright Spacer as shown. Set the Right
Upright Spacer on the Base (60).
See the inset drawing. Tie the wire tie in the
Right Upright (79) securely around the end of
the Upright Wire (86). With the help of a second
person, hold the Right Upright near the Base
(60). Then, pull the other end of the wire tie until
the Upright Wire is routed completely through
the Right Upright.
60
Wire Tie
86
79
83
86
3
2. Attach a Wheel (90) with a 3/8" x 2" Bolt (3) and
a 3/8" Locknut (11) to the Base (60). Do not
overtighten the Locknut; the Wheel must
turn freely.
60
3
11
2
90
Wire
Tie
79
86
1
. Make sure that the power cord is unplugged.
W
ith the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (53) so that the treadmill is more stable;
do not fully fold the Frame yet.
Cut the tie securing the Upright Wire (86) to the
Base (60). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire
out of the hole.
Attach two Base Feet (88) to the Base (60) in the
locations shown with two Base Foot Spacers
(89) and two #8 x 1" Tek Screws (2). Then, at-
tach two Base Feet (88) with only #8 x 1" Tek
Screws (2).
1
60
2
53
2
2
8
8
88
2
86
88
88
89
89
Hole