User's Manual

2. Make sure that the power cord is unplugged.

Locate the Upright Wire (70) bundled around the

front of the Base (80). Cut the plastic tie securing

the Upright Wire. Then, route the Upright Wire

into the Base and out of the indicated hole.

Press a Base Cap (77) into each side of the

Base (80) (only one side is shown).

See the inset drawing. Cut the plastic tie near

the Upright Wire (70). Be careful not to damage

the Upright Wire.

Hole

Cut

Tie

Cut

3. Identify the Left Upright (75). Have a second

person hold the Left Upright near the Base (80).

See the inset drawing. Tie the wire tie in the

Left Upright (75) securely around the end of the

Upright Wire (70). Then, insert the Upright Wire

into the lower end of the Left Upright as you pull

the other end of the wire tie out of the upper end

of the Left Upright.

Wire

Tie

Wire

Tie