User's Manual

12
6. Identify the left handrail assembly (A). If there is
a wire in the Left Handrail, remove and discard it.
Hold the left handrail assembly (A) near the Left
Upright (75). Insert the wire tie on the Upright
Wire (70) into the bottom of the left handrail
assembly and out of the end as shown. Then,
pull the Upright Wire through the left handrail
assembly.
Attach the left handrail assembly (A) to the Left
Upright (75) with two 5/16" x 2 3/4" Screws (10)
and two 5/16" Star Washers (8). Make sure not
to pinch the Upright Wire (70). Do not tighten
the Screws yet.
Remove and discard the two indicated screws
(B).
Attach the right handrail assembly (not
shown) to the Right Upright (not shown) as
described above. Note: There are no wires in
the Right Upright.
10
8
A
75
Wire
Tie
70
6
B
83
31
7
7
C
7
7. Set the Console Base (83) face down on a soft
surface to avoid scratching the Console Base.
Remove and discard the four indicated screws
(C). Next, remove the Pulse Crossbar (31).
Then, remove and save the four 5/16" x 5/8"
Screws (7) from the Console Frame (87).
87
C