User's Manual

14
10. With the help of a second person, hold the con-
sole assembly near the left Handrail (71) and the
right Handrail (not shown).
Connect the ground wire from the console
assembly to the Console Ground Wire (89) on
the Pulse Crossbar (31).
See the inset drawing. Connect the Upright
Wire (70) to the console wire. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Then, remove the wire tie from
the Upright Wire.
10
Console
Assembly
70
70
Wire
Tie
Console
Wire
Console
Wire
71
89
Ground
Wire
31
11. Set the console assembly on the left and right
Handrails (71). Make sure that no wires are
pinched. Insert the excess Upright Wire (70)
behind the Console Frame (87).
Attach the console assembly to the brackets
on the Handrails (71) with the four 5/16" x 5/8"
Screws (7) that you removed in step 7. Do not
tighten the Screws yet.
11
71
Console
Assembly
7
7
70
71
87