User's Manual

15. Attach a Wheel (81) to the Base (80) with a 3/8"

x 2 1/2" Bolt (2) and a 3/8" Nut (3). Do not over-

tighten the Nut; the Wheel must turn freely.

Attach the other Wheel (81) to the other side

of the Base (80) in the same way.

Lower the Frame (not shown) (see HOW TO

LOWER THE TREADMILL FOR USE on

page 25).

Latch

Knob

14. Raise the Frame (49) to the position shown.

Have a second person hold the Frame until

this step is completed.

Orient the Storage Latch (51) so that the large

barrel and the latch knob are oriented as shown.

Attach the lower end of the Storage Latch (51) to

the Base (80) with a 3/8" x 2" Bolt (12) and a 3/8"

Nut (3).

Attach the upper end of the Storage Latch (51)

to the Frame (49) with a 3/8" x 2" Bolt (12) and a

3/8" Nut (3).

16. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic

on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To

avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure

place; the hex key is used to adjust the walking belt (see pages 27 and 28). Note: Extra hardware may be

included.

Large

Barrel