User's Manual

enter the numerical code into the indicated field.

Follow any other instructions on the web page.

When the console is connected to a wireless

network, the wireless symbol in the display will

stop flashing and become solid. The wireless sym-

bol will show the strength of your wireless signal;

four arcs indicate full signal strength.

If you cannot complete any part of this

process, or if you have any questions, go to

support.ifit.com for assistance.

6. Use WiFi–Advanced to set up a wireless

connection.

This option will allow you to set up a wireless

network connection using your computer, smart

phone, tablet, or other Wi-Fi device.

On your computer, smart phone, tablet, or other

Wi-Fi device, open the list of available networks

to which your device can connect. One of the

options will be IFIT_SETUP; select this network. If

this network does not appear, make sure that your

Wi-Fi device is within range of the console, and

then close and re-open your list of networks. Also,

see Clear WiFi Setting on page 26 and clear any

previous wireless network settings on the console.

Note: The network IFIT_SETUP will not appear

if the console has already been configured to

connect to a wireless network.

The console will display an IP address, such as

192.168.0.1:8080. Open a web browser on your

computer, smart phone, tablet, or other Wi-Fi

device. Next, type in the IP address on the con-

sole into the URL bar in your browser. Example:

http://192.168.0.1:8080.

Your browser will load a web page. If the web page

does not appear, double-check the IP address and

the previous instructions of this step. Follow the

instructions on the web page to connect the tread-

mill to your wireless network.

Note: A warning may appear stating that the server

cannot be identified. If this happens, make sure

that you have entered the IP address correctly.

If you cannot complete any part of this

process, or if you have any questions, go to

support.ifit.com for assistance.

7. Exit the settings mode.

To exit the settings mode, remove the key from the

console.