Use and Care Manual

20. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic

on the treadmill decals, remove the plastic. To protect the ﬂ oor or carpet, place a mat under the treadmill. To

avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure

place; one of the hex keys is used to adjust the walking belt (see pages 30 and 31). Note: Extra parts may be

included.

19. Carefully slide the Upright Crossbar (88)

between the Left and Right Uprights (89, 90).

Attach the Upright Crossbar with the four 5/16"

x 3/4" Screws (25) that you removed in step 5

and four 5/16" Star Washers (11); start all four

Screws, and then tighten them.

110

Start First

18. Press the two tabs on the Tablet Holder (110)

into the slots (K) in the console assembly (F).

Attach the Tablet Holder (110) to the console

assembly (F) with four #8" x 5/8" Machine

Screws (115). Note: Start the two top Machine

Screws ﬁ rst, and then start the two bottom

Machine Screws. Be careful not to over-

tighten the Machine Screws.

IMPORTANT: The Tablet Holder (110) is

designed for use with most full-size tablets.

Do not place any other electronic device or

object in the Tablet Holder.

115