User's Manual

8
4. Identify the Right Upright (89) and the Right
Upright Spacer (91), which are marked with
stickers.
Insert the Wire Harness (88) through the Right
U
pright Spacer (91) as shown. Then, set the
Right Upright Spacer on the Base (95).
With the help of a second person, hold the Right
Upright (89) near the Base (95). See the inset
drawing. Tie the long tie in the Right Upright se-
curely around the end of the Wire Harness (88).
Then, pull the other end of the long tie until the
Wire Harness is routed completely through the
Right Upright.
4
Long
Tie
89
88
9
5
8
8
89
91
88
Long
Tie
5. Hold a Bolt Spacer (90) inside the lower end of
the Right Upright (89). Insert an M10 x 95mm
Bolt (8) with an M10 Star Washer (9) into the
Right Upright and the Bolt Spacer. Repeat this
step with a second Bolt Spacer (90), M10 x
95mm Bolt (8), and M10 Star Washer (9).
Hold the Right Upright (89) against the Right
Upright Spacer (91). Be careful not to pinch
the Wire Harness (88). Tighten the M10 x
95mm Bolts (8) until the heads of the Bolts
touch the Right Upright; do not fully tighten
the Bolts yet.
91
89
88
9
90
8
5
6. Press a Base Cap (87) into the Base (95).
87
95
6