Owner's Manual

14. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

elliptical exerciser.

13. The Console (11) can be operated with four 1.5V

“D” batteries (not included); alkaline batteries are

recommended. IMPORTANT: If the elliptical

exerciser has been exposed to cold temper-

atures, allow it to warm to room temperature

before inserting batteries into the Console. If

you do not do this, the console displays or

other electronic components may become

damaged. Remove the battery cover and insert

four batteries into the Console. Make sure that

the batteries are oriented as shown at the right.

Then, reattach the battery cover.

The Console (11) can also be operated with an

optional power supply (not included). To pur-

chase a power supply, call the telephone

number on the front cover of this manual. To

avoid damaging the console, use only a

manufacturer-supplied power supply. Plug

one end of the power supply into the jack on the

console; plug the other end into an outlet

installed in accordance with all local codes and

ordinances.

Battery

Cover

Batteries

12. Tip: Avoid pinching the wire harnesses dur-

ing this step.

While another person holds the Console (11)

near the Upright (10), connect the console wire

harness to the Upper Wire Harness (65).

Attach the Console (11) to the Upright (10) with

four M4 x 16mm Round Head Screws (92).

Console Wire

Harness

Avoid pinching the

wire harnesses

during this step