Exercise Bike User's Manual

6. While another person holds the Upright (13) in the

position shown, connect the console wire to the Reed

Switch Wire (43). Next, connect the console cable to

the Lower Cable (36) in the following way:

• Refer to inset drawing A. Pull up on the metal brack-

et on the Lower Cable (36), and insert the tip of the

console cable (CC) into the wire clip inside of the

metal bracket.

• Refer to inset drawing B. Firmly pull the console

cable (CC) and slide it into the metal bracket on the

Lower Cable (36) as shown.

• Refer to inset drawing C. Using pliers, squeeze the

prongs on the upper end of the metal bracket

together.

Insert the excess wire and cable down into the Frame

(1). Insert the Upright (13) into the Frame. Make sure

that the wires and cables are not pinched. Attach

the Upright to the Frame with three M8 x 25mm Button

Screws (47) and three M8 Black Split Washers (42).

7. Attach the Seat (12) to the Seat Post (5) with four M8

Nylon Locknuts (10) and four M8 Black Split Washers

(42). Note: The Nylon Locknuts and Split Washers

may be preattached to the Seat.

Turn the Seat Knob (28) counterclockwise two or three

turns to loosen it (if the Seat Knob is not loosened

enough, it may scratch the Seat Post [5]). Next, pull the

Seat Knob, slide the Seat Post into the Frame (1), and

then release the Seat Knob. Move the Seat Post up

and down slightly until the pin on the Seat Knob

snaps into one of the holes in the Seat Post. Then,

turn the Seat Knob clockwise until it is tight.

47 nsole

C_n_ r1

BMet_let _(I

CC i

Metal j

Bracket

......

12 /