Owner's Manual

12
15. Remove the Resistance Knob (88) from a resis-
tance assembly. Make sure that the 3/8" x 4
3/4" Bolt (90) stays inside of the resistance
assembly and that the resistance assembly
d
oes not come apart. Note: See the lower
drawing to reassemble the resistance assembly
if necessary.
I
nsert the Resistance Cone (85) into the Upright
Insert (84) in the Left Upright (77), with the two
large holes on top as shown. Then, tighten the
Resistance Knob (88) onto the 3/8" x 4 3/4" Bolt
(90).
Attach the other resistance assembly to the
Right Upright (92) in the same way.
88
Large
Holes
90
88
8
4
92
Large
Holes
8
5
90
15
7
7
16. Insert the end of a Crosswalk Arm (82) into the
hole in the top of a resistance assembly. Make
sure that the bend in the Crosswalk Arm is
positioned as shown.
Tighten the #8 x 3/4" Screw (1) into the resis-
tance assembly and Crosswalk Arm (82) from
the direction shown. Press a Small Cap (89) into
the hole for the Screw.
Attach the other Crosswalk Arm (82) as de-
scribed above.
82
1
Hole
89
1
82
89
16
Bend
Resistance
Assembly
Bend
R
esistance
Assembly