Owner's Manual

3. Identify the Right Upright (92) and the Right

Upright Spacer (100), which are marked with

stickers. Insert the Wire Harness (91) through

the Right Upright Spacer as shown. Set the

Right Upright Spacer on the Base (96).

See the inset drawing. Tie the wire tie in the

Right Upright (92) securely around the end of

the Wire Harness (91). With the help of a sec-

ond person, hold the Right Upright near the

Base (96). Then, pull the other end of the wire

tie until the Wire Harness is routed completely

through the Right Upright.

Wire Tie

100

2. Attach a Wheel (99) with a 3/8" x 2" Bolt (9) and

a 3/8" Nut (10) to the Base (96). Do not over-

tighten the Nut; the Wheel must turn freely.

Wire

Tie

. Make sure that the power cord is unplugged.

ith the help of a second person, carefully tip

the treadmill onto its left side. Partially fold the

Frame (48) so that the treadmill is more stable;

do not fully fold the Frame yet.

Cut the shipping tie securing the Wire Harness

(91) to the Base (96). Locate the plastic tie in

the indicated hole in the Base, and use the tie to

pull the Wire Harness out of the hole.

Attach two Base Feet (97) to the Base (96) in the

locations shown with two Base Foot Spacers

(98) and two #8 x 1" Tek Screws (6).

Then, attach the other two Base Feet (97) with

two #8 x 1" Tek Screws (6).

Hole