Owner's Manual

MAINTENANCE AND TROUBLESHOOTING

nspect and tighten all parts of the exercise bike regu-

larly. To clean the exercise bike, use a damp cloth and

a small amount of mild detergent; never use abra-

sives or solvents to clean the exercise bike. To

void damaging the console, keep liquid away

from the console.

CONSOLE TROUBLESHOOTING

If the console does not function properly, replace all

the batteries at the same time. See assembly step 7

on page 8 for battery installation instructions.

ADJUSTING THE BELT

The exercise bike features a precision belt that must

be kept properly adjusted. If the belt is too tight, the

bearings may be damaged; if the belt is too loose, the

fan may be damaged. If the belt causes excessive

noise or slips as you pedal, follow the steps below.

Carefully remove the four Guard Clips (76), the left

Guard Fastener (35), and the Left Guard (13). See the

inset drawing. Press downward on the Belt (22).

There should be no more than 3/4 in. (2 cm), and

no less than 1/4 in. (0.6 cm), of vertical movement

in the center of the Belt.

f the Belt (22) needs to be adjusted, first loosen the

right Guard Fastener (not shown). To tighten the Belt,

turn the M6 Nuts (53) clockwise; to loosen the Belt,

turn the M6 Nuts counterclockwise.

See the drawing at the left. Make sure that the Fan

(5) is straight, and then reattach the Left Guard (13),

tighten the Guard Fasteners (35), and reattach the

Guard Clips (76).