Owner's Manual

ADJUSTING THE REED SWITCH

If the console does not display correct feedback, the

eed switch should be adjusted.

o adjust the reed switch, the Right Shield (18) must

be moved. Remove the four M4 x 25mm Screws (69)

from the Right Shield. Lift the Right Link Arm (16) off

the pedal or the lock rod and move it clear of the Right

Shield. Then, pull the top of the Right Shield away

from the Left Shield (17).

Next, locate the Reed Switch (31). Turn the Crank Arm

(26) until the Magnet (48) is aligned with the Reed

Switch.

Loosen, but do not remove, the M4 x 12.7mm Flange

Screw (27). Then, slide the Reed Switch (31) slightly

closer to or away from the Magnet (48) and retighten

the Screw. Turn the Crank Arm (26) for a moment.

Repeat these actions until the console displays correct

feedback. When the reed switch is correctly adjusted,

reattach the right shield.

Lock Rod