Owner's Manual

9
10
10. Apply grease to two Wave Washers (78). Slide
a Wave Washer onto each end of the
Handlebar Axle (33).
Slide the Left and Right Handlebars (7, 9) onto
the Handlebar Axle (33). Make sure that each
Handlebar is on the correct side of the exer-
cise bike.
Tighten an M8 x 16mm Patch Screw (84), a
Small Axle Cover (49), and an M8 Washer (85)
into each end of the Handlebar Axle (33) at the
same time.
49
49
78
78
33
85
85
84
84
9
9. Identify the Right Handlebar (9) and the Right
Handlebar Base (10), which are marked with
“Right” stickers. Orient these parts so that the
w
ide side of the tube on the Right Handlebar
and the Right Link Arm (16) are on the same
s
ide.
Attach the Right Handlebar (9) to the Right
Handlebar Base (10) with two M6 x 38mm
Button Bolts (57) and two M6 Locknuts (56).
Make sure that the Locknuts are in the
hexagonal holes.
Attach the Left Handlebar (not shown) to the
Left Handlebar Base (not shown) in the
same way.
9
10
16
57
56
Wide Side
of the Tube
Hexagonal
Holes
9
7
Grease