Owner's Manual

. Push down the seat lever (not shown) on the right side

of the Seat Carriage Assembly (10), slide the Seat

Carriage Assembly into the Seat Rail (78), and then

pull the seat lever back up.

Attach a Bumper (51) to the Seat Rail (78) with an

M4 x 20mm Screw (56). Next, press the Frame Rail

Endcap (50) into the end of the Frame Rail (52).

eat

Lever

9. The Console (4) requires four 1.5V “D” batteries (not

included); alkaline batteries are recommended.

Remove the two battery covers from the Console.

Next, insert four batteries into the battery compart-

ments.

Make sure that the batteries are oriented as

shown by the diagrams inside of the battery com-

partments. Then, reattach the battery covers to the

Console.

Attach the Book Holder (23) to the Console (4) with

two M4 x 12mm Screws (41) as shown.

Batteries

Battery

Covers

10. While another person holds the Console (4) in the

position shown, connect the wire harness on the

Console to the Upper Wire Harness (42). Insert the

excess wire harness down into the Upright (2).

Attach the Console (4) to the Upright (2) with four M4

x 16mm Screws (57) and two Console Brackets (80).

Be careful to avoid pinching the wire harnesses.

ire

Harness