Owner's Manual

BATTERY INSTALLATION

The console requires two "AA" batteries (not in-

cluded). Alkaline batteries are recommended. To in-

stall batteries, first touch the handrail to discharge

any static. Next, open the battery cover as shown in

the drawing at the upper right. Insert two batteries into

the battery compartment, making sure that the negative

(–) ends of the batteries are touching the springs in the

battery compartment. Close the battery cover, push up

on the battery cover tab, and then push the tab forward

as shown in the inset drawing. Be sure that the tab

locks into place.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the

power cord is properly plugged in. (See HOW TO

PLUG IN THE POWER CORD on page 7.)

Next, step onto the foot

rails of the treadmill. Find

the clip attached to the key,

and slide the clip onto the

waistband of your clothing.

CAUTION:Before operating the

console, read the following precautions.

• Do not stand on the walking belt when turn-

ing on the power.

• Always wear the clip (see the drawing at

the lower right) while using the treadmill.

When the key is removed from the console,

the walking belt will stop.

• Adjust the speed in small increments.

• To reduce the possibility of electric shock,

keep the console dry. Avoid spilling liquids

on the console and use only a sealable

water bottle.

Battery

Cover

Battery

Cover Tab

CONSOLE DIAGRAM

On/Reset Button

Note: If there is a thin sheet

of clear plastic on the face of

the console, remove it be-

fore operating the console.

Clip

Batteries

Handrail