Owner's Manual

7
4. Apply a generous amount of the included
grease to the axle on the right side of the
Upright (6).
Identify the Right Pivot Cover (53) and the Right
Upper Body Leg (12), which are marked with
“Right” stickers, and orient them as shown. Do
not remove the wire tie from the Right Upper
Body Leg.
Slide the Right Pivot Cover (53) and the Right
Upper Body Leg (12) onto the right side of the
Upright (6).
Attach the Right Upper Body Leg (12) with a
5/16" x 1" Patch Screw (81), an Upper Body
Axle Cover (94), and a 5/16" Washer (104).
Repeat this step on the other side of the
elliptical.
4
3. Have another person hold the Upright (6) near
the Frame (1).
S
ee the inset drawing. Locate the wire tie in
the Upright (6). Tie the lower end of the wire tie
t
o the Main Wire (54). Next, pull the upper end
of the wire tie until the Main Wire is routed com-
pletely through the Upright. Then, untie and
discard the wire tie.
Tip: To prevent the Main Wire (54) from
falling into the Upright (6), secure the Main
Wire with a rubber band or tape.
Tip: Avoid pinching the Main Wire (54). Insert
the Upright (6) into the Frame (1). Attach the
Upright with a 5/16" x 1" Patch Screw (81) and
a 5/16" Split Washer (105) in the indicated loca-
tion.
3
Avoid pinching the
Main Wire (54)
81
105
54
54
Wire Tie
Wire
Tie
53
12
Wire Tie
94
6
Grease
6
6
1
81
104
W
ire
Tie