User Manual

Air Remote – Air Sync
15
www.profoto.com
Operating instructions
Remote flash Synchronization
Profoto Air devices can be used to remotely synchronize flash generators and various
speedlights equipped with a PC terminal.
Camera setup
Connect the Profoto Air device to the camera, using one of the following methods:
a) Slide the Hot Shoe Connector [19] on the
Profoto Air device into the camera’s hot
shoe.
b) Connect a sync cable from the camera
to the In Connector [16] on the Profoto Air
device.
Generator setup (without built-in Profoto Air)
1. Connect the Profoto Air device to the
generator, via a cable from the Out Connector
[18] on the device to the sync input socket
on the generator or the PC terminal on the
speedlight.
2. Press and hold down the On Button [5] to
turn on the Profoto Air device.
3. Press the Channel Button [2] until the
desired Channel Indicator [1] is illuminated.
The selected channel shall be the same for
all generators.
4. Press the Mode Button [4] and verify that the Receive Indicator [7] is illuminated.
5. For proper setup when using a speedlight, consult the user manual of the actual
speedlight.