User Manual

Air Remote – Air Sync
18
www.profoto.com
Release of remote camera
Two Profoto Air devices (receiver and transmitter) can be used for wireless remote camera
release. In this case, the camera has to be equipped with an electronic shutter release
connection.
Camera setup
1. For a single shot, set the camera to single mode. If the camera is set to continuous
mode, the camera will continue shooting as long as the Test Button [6] is held down.
Continuous mode is recommended for shooting with 2 fps or faster.
2. Connect a camera release cable corresponding to the camera in use (Canon,
Hasselblad, Nikon, Phase One,…) from the camera to the In Connector [17] on the
Profoto Air device.
Note!
If releasing camera in single mode and more than 2 fps is needed, the cable from the camera should be connected to
the Out Connector [18] on the Profoto Air device. This connection is only recommended if the camera is set to manual
focus or if a pre-release cable is used to connect the camera and the unit. For more information on pre-release
functionality, see section on Camera release cables.