Instruction manual

PLEASE NOTE! The energy output is determined by the energy dials A and B. The energy out-

put will remain consistent, regardless of which lamp sockets are used or the number of lamp

heads connected to them. Energy dumping is not necessary as long as the dial MASTER is

turned to MAX.

Energy Control

The generator’s total energy is regulated with the control MASTER (6). The total energy can be

adjusted in 1/6 f:stop increments from MAX down to minus 8/6 f:stops equivalent to 1 1/3

f:stops. When reducing the energy a ﬂash has to be released with the white push-button [11]. Then

the chosen energy is obtained. Please also see ”Manual Bracketing” (page 20), ”Autobracket-

ing” (page 20) and ”Colour Temperature” (page 23).

Choice of Modelling Light

The control [15] MOD. LIGHT is used to choose the following alternatives:

• OFF Modelling light off

• 1/1 Modelling light is receiving the designated proportional full energy determined by the

positions of dials A, B & MASTER

• 1/2 Modelling light is receiving the designated proportional half energy determined by

the positions of dials A, B & MASTER

• MAX Modelling light is at maximum, regardless of energy settings

Half proportional modelling light is chosen when a Pro-7a/1200 and a Pro-7a/2400 are used

together. To keep the modelling light proportionally aligned between the two generators, the

Pro-7a/1200 is set to a 1/2 modelling light position, as the flash energy is half of the

Pro-7a/2400.

[4] [6] [9]