Instructions / Assembly

Make
the Electric
Connections
WARNING:
To avoid possible electrical
shock, be sure electricity is turned off at the
main f
use box before wiring.
CODE SWITCH: Codes are set by pushing dip
switches up or down. It is imperative that the
code used for both transmitter and receiver is
exactly the same, otherwise remote controller
will not work. Please note the code switch will
enable
you to operate a second remote
controller independently. For example, if you
have two ceiling fans with 2 remote control
units, set 2 different codes for each set of
transmitter/receivers. This means you can
operate each ceiling fan independently.
You
r remote control is ready for use after
battery installation.
(Fig.8)
Step 1. Fan motor to Receiver Electrical
Connections: Connect the Black wire from the
fan motor to Black wire marked "to fan motor
L". Connect the White wire from the fan motor
to the White wire marked " to fan motor N "
from the receiver. Connect the blue wire from
the light to the blue wire from the Receiver.
Secure wire connections with the plastic wire
nuts provided. (Fig. 9)
Step 2. Receiver to House Supply Wires
Electrical Connections: Connect the black (hot)
wire from the ceiling to the black wire
marked "AC in L" from the receiver.
Connect the white (neutral) wire from the
ceiling to the white wire marked "AC in N"
from the Receiver. Secure the wire connections
with the plastic wire nuts provided. (Fig. 9)
Step 3. If your outlet box has a ground wire
(green or bare copper) connect it to the fan
ground wires; otherwise connect the hanging
bracket ground wire to the mounting bracket.
Secure the wire connection with a plastic nut
provided. After connecting the wires spread
them apart so that the green and white wires are
on one side of the outlet box and black and blue
wires are on the other side. Carefully tuck the
wire connections up into the outlet box. (Fig.
9)
ON DIP
1 23 4
Blue(for light)
Black
(for Fan motor)
Blue(to light)
Black
("to Fan motor L")
White(neutral)
White
("to Fan motor N")
Receiver
Outlet box
Green
Green (ground)
White ("AC IN N")
Black
("AC IN L")
Black (hot)
White(neutral)
Fan motor
Figure 9