Instructions / Assembly

If using close-to-ceiling mounting, hang the
(Figure 12a)
bracket aligned with the slot in the ball.
until it is seated with the tab of the mounting
bracket.
assembly into the socket of the mounting
the mounting bracket.
center hole in the mounting bracket.
face toward the outlet box, as shown.
at side of the mounting bracket should
washers (not included) between the
box by using the two screws provided with
Install the mounting bracket on the outlet
Installing Fan to
the Electrical Box
WHEN MOUNTING THE FAN ON
A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING BRACKET MUST BE MOUNTED
SO THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
BRACKET FROM THE TOP DOWN.
1. Pass the 120-Volt supply wires through the
(Figure 1
1)
2.
the outlet box. If necessary, use leveling
mounting bracket and the outlet box.
The
(Figure 11)
3. Securely tighten the two mounting screws.
Figure 11
Washers
120V Wires
UL Listed
Electrical
Box
Ceiling
Mounting
Bracket
Hook
Mounting
Screws
(Supplied with
Electrical Box)
WHEN USING THE STANDARD
BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
Figure 12a
Figure 12b
Standard Mount
Close-to-Ceiling Mount
6.
4. Carefully lift the fan-motor assembly up to
5. Insert the ball portion of the ball/downrod
6. Turn the ball/downrod assembly clockwise
7.
fan on the hook provided by utilizing one
of the holes at the outer rim of the ceiling
canopy. (Figure 12b)