Installation Guide

Hanging the Fan
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 1. Insert the end of downrod (B) through
the connector (PP),align the two holes in the
downrod (B) and the connector (PP).(Fig.5)
Step 2. Insert a plug pin (GG) through the two
holes in the downrod (B) and the connector (PP).
(Fig.5)
Step 3. Insert the R-shaped pin (HH) though the
hole near the end of the plug pin (GG) until it
snaps into its locked position. (Fig.5)
Step 4. Install the screw (FF) to the connector
(PP), and make sure it’s tighten. (Fig.5)
Step 5. Insert the canopy (C) and metal cover
(D) through the downrod (B). (Fig.6)
Step 6. Insert the hanger ball (J) through the
downrod (B), and then insert a plug pin (L)
through the hole in the downrod (B). (Fig.6)
Step 7. Insert the plug pin to the slot cut off in
the hanger ball (J) until it snaps into its locked
position. (Fig.6)
Step 8. Install the Hanger bracket (A) on the
outlet box by using the washer and screws are
provided with the junction box. (Fig.7)
Step 9. Put the hanger ball (J) through the open
side of the ceiling mounting bracket, and then
insert the hanger ball to the slot cut off in the
ceiling mounting bracket. (Fig.7)
4.