Installation Guide
Table Of Contents
- PLO188-P250022-E-Cover
- PLO188-P250022-Warranty
- PLO188-P250022-E-P0
- PLO188-P250022-E-P1a
- PLO188-P250022-E-P2
- PLO188-P250022-E-P3
- PLO188-P250022-E-P4
- PLO188-P250022-E-P5
- PLO188-P250022-E-P6a
- PLO188-P250022-E-P6b
- PLO188-P250022-E-P7
- PLO188-P250022-E-P8
- PLO188-P250022-E-P9
- PLO188-P250022-E-P10
- PLO188-P250022-E-P11
- PLO188-P250022-E-P12
- PLO188-P250022-S-Cover
- PLO188-P250022-S-Warranty
- PLO188-P250022-S-P0
- PLO188-P250022-S-P1a
- PLO188-P250022-S-P2
- PLO188-P250022-S-P3
- PLO188-P250022-S-P4
- PLO188-P250022-S-P5
- PLO188-P250022-S-P6a
- PLO188-P250022-S-P6b
- PLO188-P250022-S-P7
- PLO188-P250022-S-P8
- PLO188-P250022-S-P9
- PLO188-P250022-S-P10
- PLO188-P250022-S-P11
- PLO188-P250022-S-P12
9.
Installing the
Decorative Cover
CAUTION: Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Step 1. Remove the 3 screws from the
mounting plate A. (Fig. 16)
Step 2. Secure the mounting plate B to the
mounting plate A by tightening the three
mounting screws previously removed.
Step 3.
Fit the decorative cover onto the
mounting plate B
.
Figure 16
Screws
Mounting plate A
Decorative
cover
Mounting
plate B
Installing the battery
Install a 12V battery (included) into the remote
control. To prevent damage to the remote control,
remove the battery if not used for long periods. (Fig.
17)
Figure 17