Installation Guide

Finishing the Installation

Step 1. Tuck connections neatly into ceiling

outlet box.

Step 2. Slide the canopy up to mounting bracket

and place the key hole on the canopy over the

screw on the mounting bracket, turn canopy until

it locks in place at the narrow section of the key

holes. (Fig. 10)

Step 3. Align the circular hole on canopy with the

remaining hole on the mounting bracket, secure

by tightening the two set screws. Note: Adjust the

canopy screws as necessary until the canopy and

canopy cover are snug.

WARNING

Make sure the notch on the hanging bracket

properly sits in the groove in the hanger ball

before attaching the canopy to the bracket by

turning the housing until it drops into place.

Figure 10

Outlet box

Hanger

bracket

Canopy

Canopy cover

Screws

Figure 11

Screws

Blades

Blade arms

Fiber

washers

Attaching the Fan Blades

Step 1. Attach the blades to the blade arms using

three screws and fiber washers as shown in Figure

11. Start a screw into the blade arm, do not

tighten. Repeat for the 2 remaining screws and

washers.

Step 2. Tighten each screw securely starting with

the center screw. Make sure the blade is straight.

Step 3. Insert the blade arm through the slot in the

housing. Align the holes in the blade arm and the

fan motor assembly and secure with the screw

with lock washer.

Step 4. Repeat these steps for the remaining

blades.