Installation Guide

Finishing the Installation

Step 1. Tuck connections neatly into ceiling

outlet box.

Step 2. Slide the canopy up to mounting bracket

and place the key hole on the canopy over the

screw on the mounting bracket, turn canopy until

it locks in place at the narrow section of the key

holes. (Fig. 10)

Step 3. Align the circular hole on canopy with the

remaining hole on the mounting bracket, secure

by tightening the two set screws. Note: Adjust the

canopy screws as necessary until the canopy and

canopy cover are snug.

Attaching the Blade Holders

Step 1. Insert the blade holder through the slot in

the housing. Align the holes in the blade and the

fan motor assembly and secure with the blade

holder attachment screws

(1/4"x22mm) with lock

washers. (Fig. 11)

Step 2. Repeat this procedure with the remaining

blade holders.

WARNING

Make sure the notch on the hanging bracket

properly sits in the groove in the hanger ball

before attaching the canopy to the bracket by

turning the housing until it drops into place.

Figure 10

Outlet box

Hanger

bracket

Canopy

Canopy cover

Screws

Figure 11

Screws (1/4"x22mm)

with lock washers

Blade holders