Specifications

7.
Attaching the Fan
Blades
Figure 15
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
1. Align the locking slots of the ceiling
canopy with the two screws in the
mounting plate. Push up to engage the
slots and turn clockwise to lock in place.
Immediately tighten the two mounting
screws rmly.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
rmly.
3. Install the decorative canopy ring by
aligning the ring’s slots with the screws
in the canopy. Rotate the ring counter-
clockwise to lock in place.
4. You may now proceed to attaching the
fan blades.
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Attach blade to blade bracket using the
screws as shown in gure 15. Start a
screw into the bracket. Repeat for the two
remaining screws.
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor by
inserting the alignment post into the slot on
the bottom of the motor and tightening the
motor screws. Please note that the motor
screws are pre-attached into the blade
brackets (Figure 16).
4. Repeat steps 1, 2 and 3 for the remaining
blades.
Note: Your fan blades are reversible. Select the
blade nish which best accentuates your decor.
Figure 16
Blade
Screws
Blade arm
Motor Assembly
Screws
Figure 14