Installation Guide

Figure 14

Finishing the Installation

Step 1. Tuck connections neatly into ceiling

outlet box.

Step 2. Slide the canopy up to hanger bracket and

place the key hole on the canopy over the screw

on the hanger bracket, turn canopy until it locks in

place at the narrow section of the key holes. (Fig.

14)

Step 3. Align the circular hole on canopy with

the remaining hole on the hanger bracket, secure

by tightening the two set screws. NOTE: Adjust

the canopy screws as necessary until the canopy

and canopy cover are snug.

Installing the battery

Figure 15

Install a 12V MN21/A23 battery (included) into

the remote control. To prevent damage to the

remote control, remove the battery if not used for

long periods. (Fig. 15)

Outlet box

Hanger

bracket

Canopy

cover

Screws