Installation Guide

7.
Fiber
washer
Blade
arm
Figure 9
Blade
Screws
Attaching the Fan
Blades
Step 1 Attach the blades to the blade arms
using three screws and fiber washers as shown
in Fig. 9. Start a screw into the arm, do not
tighten. Repeat for the 2 remaining screws and
washers.
Step 2 Tighten each screw securely starting
with the center screw. Make sure the blade is
straight.
NOTE: Your fan blades are reversible. Select
the blade side finish which best accentuates
your decor.
Fasten the blade assembly to the motor
using the motor screws provided.
Step 3
(Fig. 10)
Step 4 Install an optional light kit if you wish.
Follow the instructions included with the kit.
Figure 10
Motor
Blade arm
Blade blancing
deviation
3. Use the enclosed Blade Balancing Kit if
the blade wobble is still noticeable.
4. If the blade wobble is still noticeable,
interchanging two adjacent (side by side)
blades can redistribute the weight and
possibly result in smoother operation.
All blades are grouped by weight. Because
natural woods very in density, the fan may
wobble even though the blades are weighed
equally.
The following procedure should correct
most fan wobbling problems. Check after
each step.
1. Check that all blade and blade arm
screws are secure.
2. Most fan wobbling problems are caused
when blade levels are unequal. Check this
level by selecting a point on the ceiling
above the tip of one of the blades. Measure
this distance as shown in Figure 11. Rotate
the fan until the next blade is positioned for
measurement. Repeat for each blade. The
distance should be equal within
1/8".
'