Instructions / Assembly

Attaching the Switch
Cup Adaptor/
Attaching the Switch
Cup
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the switch cup
adaptor and switch.
1. Remove one screw from the black bracket
below the fan motor assembly. Loosen, but
do not remove the other two screws. Align
the key hole slots in the switch cup adaptor
with the two screws in the black bracket.
(Figure 14)
2. Turn the switch cup adaptor clockwise until
the two screws are situated in the narrow
end
of the keyholes. Re-install the one screw that
was removed in step 1. Tighten all three
screws firmly. (Figure 14)
3.
4.
Remove three screws from the switch cup
adaptor. Connect the molded adaptor plug
in
the switch cup with the molded adaptor plug
of the fan motor assembly. (Figure 15)
Attach the switch cup to the fan by aligning
the three screws holes on switch cup with the
screw holes on the switch cup adaptor Install
the three screws that were removed in step 3.
Tighten all three screws firmly. (Figure 15)
screw
Screws
Switch cup adaptor
Switch cup
Figure 14
Figure 15
9.
Attaching the Fan with
the Optional Light
Fixture (not supplied)
For optional light xture installation, remove
the reverse module and the bottom cover to
easily feed the light kit wires through the
threaded hole in the center of the switch
housing (Figure 16). After the light kit is
attached to the switch cup, replace the module
to its original position.
Figure 16
YOU WILL NEED THE FLAT HEAD
SCREWDRIVER TO ACCESS THE HEAD OF
BOTTOM COVER TO REMOVE THE COVER
FROM SWITCH HOUSING.
Reverse
module
Switch cup
Bottom
cover