Installation Guide

8.
Installing the Light Kit
Pan/Light Kit Fitter
Assembly/Glass Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
THE GLASS IS FRAGILE, USE CARE
WHEN INSTALLING THE LIGHT KIT AND
THE GLASS SHADE.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 13)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads t into the keyhole slots. Turn the
light kit pan clockwise, tighten the screws.
Re-install the screw that was removed in
step 1 and tightened rmly.
3. Remove one screw from the light kit pan
and loosen, but do not remove the other
two screws. Connect the wires from the
light kit tter assembly to the wires from
the fan motor assembly by connecting the
molded adaptor plugs together. Carefully
tuck all wires and splices into the switch
cup. (Figure 14)
4. Push the light kit tter assembly up so
that the two loosened screw heads t into
the keyhole slots. Turn the light kit tter
assembly clockwise, tighten the screws.
Re-install the screw that was removed in
step 3 and tighten rmly. (Figure 14)
5. Remove three screws from the side of the
light kit pan. Align the three screw holes
on the frame with the three screw holes on
the light kit pan. Re-install the screws to
the three screw holes and tighten rmly to
secure. (Figure 15)
Light Kit
Pan
Mounting
Screw (3)
Light Kit
pan
Glass shade
with frame
Screw (3)
Figure 14
Figure 15
Blue
White
White
Black
Screw
Light Kit
Fitter
Assembly
Molded
Adaptor
Plugs
Figure 13