Installation Guide

Installing the Light Kit 8.
Figure 13
NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power off using the fan switch is not sufficient to
prevent electric shock.
1. While holding the light kit assembly under your fan, snap together the wire connector plug.
2. Carefully push all wires back into the switch housing, then install the light kit assembly onto
the mounting plate with 4 screws provided. Be sure to tighten all screws. (Fig. 13)
3. Install 2 x LED bulbs (included).
4. Insert the fan pull chain through the eyelet in the shade and cap. Also insert the light kit pull
chain through the shade and cap. Attach the two pull chains provided to the light kit pull chain
& fan pull chain.
5. Raise the light kit shade to the fitter and secure tightly with the glass cap and decorative nut.
(Fig. 13)
Screws
Connector plugs
Pull chains
Light kit
assembly
Mounting
plate
Glass
shade
Glass cap
Decorative nut
Bulbs